How can I add keepouts?

2 years ago Updated

After drawing the PV Array, click on “Draw Keepouts”. You can select from “Freeform”, “Rectangle”, “Circle” or “Tree”.

If you select "Freeform", draw the outline of the keepout and right click to adjust the height and setback.

If you select "Tree", enter the radius of the tree and right click on the tree to adjust the height.

Comments

0 comments

Article is closed for comments.

Related Articles
How do I add inverters?
Paige Bassano 2 years ago Updated FollowNot yet followed by anyone Click on the “Inverter” tab and then “Add Inverter”. System size can be seen on the top so you can add the inverter accordingly. Note: Add inverters so that the DC to AC Ratio is as ...
How do I add storage?
Paige Bassano 2 years ago Updated FollowNot yet followed by anyone Click on the “Storage” tab, then select the manufacturer, model and quantity. You can customize reserve % as per use. Was this article helpful? Yes No0 out of 0 found this helpful ...
How can I view the kWh Offset preview?
Paige Bassano 2 years ago Updated FollowNot yet followed by anyone Click on “System Results” to view the detailed post solar analysis. Click on “Detailed Utility Rate Analysis” to view several Savings Analysis graphs. Was this article helpful? Yes ...
Can I change the post PV rate?
Paige Bassano 2 years ago Updated FollowNot yet followed by anyone Yes, click on the “Additional Choices” tab. Select post PV electric rate from the drop-down menu. You can also change the utility escalator percentage over the year. Was this article ...
How can I view the project in 3D?
Paige Bassano 2 years ago Updated FollowNot yet followed by anyone Once you have outlined the roof, added the array and any obstacles, the 3D button will be enabled. You can then click on the "3D" button , to view image in 3D mode. Also , A variety ...